Komatsu — Attachment Installation

OPTIONS, ATTACHMENTS Attachment Installation 1. Remove the bucket. For bucket dismounting procedure, see “BUCKET REPLACE- MENT AND INVERSION” on page 2-171. 2. Place the attachment in a horizontal position, then install to the arm with pin (A) and then pin (B). 3. Lower the attachment to the ground and stop the engine. 4. Turn the starting switch to the ON position (B), then set the lock lever to the FREE position (F). 5. Operate each work equipment control lever and the attachment control pedal back and forth, left and right at full stroke two to three times to eliminate the internal pressure in the hydraulic circuit. 6. Set the lock lever to LOCK position (L). PC200LC-8 5-19