Operating Instructions for Starting the Engine 6. Start the engine with the accelerator pedal in the idle position. Monitor the oil pressure gauge or indicator lamp. Keep the engine running at idling speed until the oil pressure reading is 14 psi (97 kPa) or more. 7. Allow engine to reach operating temperature 60єC (140єF). NOTICE: Increasing engine speed above idle before oil pressure has stabilized may cause severe engine damage. 8. Increase engine speed to 1800 rpm for three minutes. 9. Return the engine to idle and allow to idle for approximately one minute, then shut down the engine. 10. Check for leaks. Repair if necessary.
Checking Other Engine and ATS Related Parts Check the engine compartment as follows: Make sure the transmission is filled to the proper level with the fluid recommended by the gear manufacturer. Do not overfill. The Diesel Exhaust Fluid (DEF) must be checked and filled regularly with DEF meeting Detroit™ quality specification. Make sure cable connections to the storage batteries are clean and tight. Check for cracks in the battery cases (1), for tightness of the cable clamps (2) at the terminals, and for corrosion of the terminals (3). Service or replace as needed. To provide corrosion protection, apply dielectric grease liberally to the terminal pads.
26 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0209