Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

CHASSIS MODIFICATIONS 2-88 E URO C ARGO E URO 4 - 5 Fuel tank When tank refilling is hindered by the position of the body structure, the tank mounting brackets can be installed one drilling unit lower (45 mm), after checking that the new height complies with the minimum height above ground level. In the event that the fuel tank capacity is not enough, you may proceed as follows: a) use an original IVECO tank of greater capacity. The table below illustrates the types of tanks available. Verify that the new tank is compatible with the original vehicle configuration. Table 2.21 - Available tanks b) addition of a supplementary fuel tank.

The most thorough solution is to fit the additional tank using the same system layout as for the original tank, whenever possible using original elements, particularly the fuel level indicator. A switch can be fitted to allow the two tanks to be used alternatively. Figure 2.40 91471 The use of the above system is advisable when the added tank is located on the side opposite the original one. When the tanks are in line on the same side it is possible to maintain fuel feed from the original tank then the added one should be connected directly to the former through hoses. The arrangement must conform to national rules and regulations.

The tank-to-tank connecting line must be leakproof and not of a smaller internal dimension, have the same technical characteristics as those envisaged for the original system and be properly secured. Repositioning Parts and Mounting Auxiliary Assemblies and Equipment Base - July 2006 Revi - June 2007 Print 603.93.431 Vehicle models Fuel tanks 115 l plastic 200 l plastic 280 l aluminium 60E-120EL BASE OPT. NO 120E-130E-140E BASE OPT. OPT. BASE OPT. 150E-160E (E28-E30) OPT. BASE OPT. NO BASE