CHASSIS MODIFICATIONS 2-90 E URO C ARGO E URO 4 - 5 The choice of retarder must be made based on the following formula: i p ⋅ C f R’ ⋅ PTT ≅ 1 i P = rear axle ratio Cf = maximum braking torque (Nm) R’ = radius of the tyre used when loaded (m) PTT = total ground weight (kg) Example of calculation of retarder maximum braking torque on new EuroCargo Consider a new EuroCargo EuroCargo ML120E18R/P, with 4.88 rear axle ratio and 265/70R19.5 tyres. From the following data 1. i P = 4.88 2. R’ = 0.401m 3. PTT = 12000kg We obtain: C f = (12000 · 0.401) / 4.88 = 986 Nm Thus, a retarder brake of maximum braking torque 1000Nm can be applied.
2.25 Alterations to the rear protection bar Our vehicles are fitted with a rear protection bar in accordance with EC Directives. The maximum distance allowed by the device at the extreme rear of the body structure is 400 mm, minus the deformation resulting from the homologation (less than 20 mm). Whenever the chassis modifications affect the rear overhang, the underrun bar must be repositioned (in compliance with current regulations) so as to be able to obtain the same connection with the chassis as on the original vehicle. When modifying the vehicles or installing special equipment (e.g. tail lifts) it may be necessary to modify the structure of the underrun bar.
Such modifications must not change original resistance and stiffness specifications (comply with local government regulations, if any). The firm carrying out the modification must be prepared to present the relevant documentation on the required specifications upon request. Whenever different underrun bar must be used, check relevant current regulations. Documentation or quality control certificates must be presented upon request from the competent authority. Transporting Dangerous Cargo Base - July 2006 Revi - June 2007 Print 603.93.431