CHASSIS MODIFICATIONS 2-91 E URO C ARGO E URO 4 - 5 Front protection (FUP) 2.26 Front protection (FUP) On vehicles in the New EuroCargo range fitted with this device, the Front Underrun Protection bar (FUP) can be fixed to the frame in various positions. In this way the fitter can adjust the position of the protection, in compliance with directive CE 2000/40, according to the set-up of the fitted vehicle, the loads on the axles and/or the tyres fitted. Table 2.22 For vehicles 150E, 180E and 260EK the first cab access step is fixed to the FUP.
If a fitter intends to modify the position of the FUP he must, in this case, replace the step fixing bracket so as to guarantee that it remains in the same position with respect to the cab itself. The above requirements serve to optimise the front attitude angle of the vehicle should the FUP bar be found to be too low as a result of the fitting operations. 2.27 Rear view mirrors The dimensionsof the approved rearview mirrorsare given in the table, accordingto the width of the vehicle and the driving position.
Table 2.23 - Arms for approved rear view mirrors Figure 2.41 Front protection (FUP) Print 603.93.431 Base - July 2006 Revi - June 2007 Model Possible FUP bar fixing positions 60E, 65E, 75E, 80E, 90E, 100E, 110EL, 120EL 2 120E, 130E, 150E 4 180, 260EK 3 Guide Vehicle width Size of arms a x b x c (mm) Driver’s side Side opposite driver 2300 ÷ 2400 245 x 800 x 220 310 x 800 x 275 or 310 x 800 x 285 Left 2300 ÷ 2450 245 x 800 x 220 or 204 x 800 x 200 310 x 800 x 275 or 290 x 800 x 300 or 310 x 800 x 285 2500 ÷ 2550 355 x 800 x 333 2500 ÷ 2600 355 x 800 x 333 or 317 x 800 x 308 425 x 800 x 372 or 390 x 800 x 386 or 425 x 800 x 390 Right 2300 ÷ 2350 245 x 800 x 220 or 204 x 800 x 200 310 x 800 x 285 or 290 x 800 x 300 2500 355 x 800 x 333 425 x 800 x 390 2500 ÷ 2550 317 x 800 x 308 390 x 800 x 386 91514