Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-27 E URO C ARGO E URO 4 - 5 When this type of joint is used, the following must be observed: - The plate must only be attached to the vertical web of the main sidemembers. Before fixing ensure that the subframe is mounted correctly on the top flange with no gaps between the two mating surfaces. - Use of cleat plates must be confined to the central and rear sections of the frame. - The number of plates, thickness and number of securing bolts must be adequate to transmit the section shearing and bending moments. These values can be determined accurately by calculating them, when all the necessary elements are available.

When the bodies cause high bending and twisting moments on the chassis and its strength has to be increased by means of a shear resistant connection between the chassis frame and subframe, or the subframe height has to be limited as far as possible (e.g., towing central axle trailers, crane on rear overhang, tail lifts, etc.). Observe the instructions given in the following table: 3.4.5 Mixed Connection On the basis of instructions given for the construction of the subframe (point 3.3) and considerations included in the general section of point 3.4, the mounting between the vehicle frame and subframe can be of the mixed type, i.e.

it may be obtained through a rational use of flexible connections (brackets, clamps) and rigid connections (plates for longitudinal and transversal anchorage). As a guideline, it is advisable to have flexible connections on the front portion of the subframe (one or two on each side) while plate connections are recommended for the rear portion of the vehicle when a stiffer structure is required for the whole assembly (e.g., tippers, crane on rear overhang, etc.). Print 603.93.431 Base - July 2006 Revi - June 2007