Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-29 E URO C ARGO E URO 4 - 5 Demountable Bodies In the case of self-supporting bodies whose bearing structure operates as a subframe, the above explained installation of the reinforcing runners need not be affected. The application of box bodies and structures with high torsional stiffness in general required the use of elastic connections towards the front of the structure to avoid excessive reduction of main chassis distortion in particularly demanding applications. The front panel of the bodywork must be strong and sturdy enough to withstand the forces generated by the transported load, when braking sharply.

3.7 Demountable Bodies The construction of interchangeable equipment that is meant to be lifted off when replacement is necessary (e.g. through lifting devices or the vehicle’s air suspension itself) and then to be positioned on four supporting posts, generally requires the adoption of a subframe featuring side runner profile dimensions as specified in Table 3.6 or of adequate structures comprising coupling and hoisting devices. Adequate reinforcements must be fitted whenever concentrated loads imposed by lifting apparatus determine high stress on vehicle chassis. To ensure good operation, all vehicle stability conditions must be checked out in accordance with the suspension specifications.

Models that are equipped with a pneumatic suspension on the rear axle or full pneumatic suspension are particularly well suited for this type of use. The lifting devices acting vertically may be fitted not only on the subframe but, in special cases, also be mounted on plates of adequate dimensions connecting the chassis frame to the subframe. Regarding the connecting of bodies, especially when quick locking systems are used, it is necessary to provide adequate supports to counteract the longitudinal and transversal thrusts under dynamic conditions. The use of an underframe or special sub-structure could be avoided, if authorised by IVECO, under the following conditions:

- the interchangeable body must rest along its entire length on the vehicle chassis or at least cover most of the area where suspension attachments are; - an adequate number of coupling devices must be fitted along the side member vertical web; - lifting apparatus anchoring must be such that its loads upon the chassis are limited. Print 603.93.431 Base - July 2006 Revi - June 2007