Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

FITTING SUPER STRUCTURES 3-30 E URO C ARGO E URO 4 - 5 Building Vans 3.8 Building Box Bodies To mount the body onto the vehicle chassis, a structure made up of longitudinal runners and cross members may be built (see Figure 3.3). The dimensions of the longitudinal runners should be of the order of those shown in Table 3.6. Longitudinal runners may be dispensed with provided the cross members used for the floor structures are placed no more than 700 mm from one another, forming a sufficiently rigid (self-bearing) structure. In order to provide the required stability and to avoid the front end of the chassisbeing too rigid, the suggestions given in point 3.4 should be followed.

3.9 Tipping Bodies The use of tipping bodies, whether end or three way, subjects the chassis to notable stress. For this reason it is most important to select the right vehicle from among those intended for this use. Therefore we list here the specifications that must be adhered to for this type of construction subdivided according to light or heavy duty. Table 3.7 and Table 3.8 give the minimum runner dimensions for the subframe with which these vehicles must be equipped. Furthermore any government regulations concerning these vehicles must also be abided by. After fitting the body, the bodybuilders must ensure that the vehicle remains stable during tipping.

The following points must be kept in mind: - The subframe must be (see Figure 3.13 and Figure 3.14) suitable for the vehicle type and for the specific operating conditions. It must have adequately dimensioned side and cross members and be stiffened at the rear by box-type construction and crossbraces. Anchoring the subframe to the chassis, flexible joints brackets or shelves must be placed at the front end, whereas the rear section requires rigid-type joints (plates, see Figure 3.20) to allow the added structure to contribute more to the rigidity of the whole. - The rear tipping hinge must be mounted on the subframe as near as possible to the rear support of the rear suspension.

In order not to impair the stability of the vehicle during tipping operations and not to increase excessively the stress on the chassis, it is recommended that the distances between the tipping hinge and the rear spring support be observed in Figure 3.21. If for technical reasons this cannot be achieved, small increases may be permitted provided a higher strength subframe is used, in order to increase the rigidity of the rear end. In the case of large volume transports requiring long bodies , it is advisable (in those cases where it is permissible) to lengthen the wheelbase of the vehicle.

- Great care must be given to the positioning of the lifting device both in terms of providing supports of adequate strength and in order to position the mountings precisely and conveniently. It is advisable in any case to place the device to the front of the centre of gravity of the body plus payload so as to reduce the extent of the localised load. Base - July 2006 Revi - June 2007 Print 603.93.431