Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

POWER TAKE-OFFS 4-14 E URO C ARGO E URO 4 - 5 4.6.2 PTO 0 mode (run mode) In normal operation, an intermediate rpm ratio can be activated to a speed of 20 km/h (important note: the speed regulator will trip at speeds exceeding 20 km/h). Press Resume on the steering wheel stalk unit to activate. A new intermediate rpm ratio can be stored by the driver by holding the Resume button pressed for longer (>5s). Consequently, no programming by IVECO Service is required. The maximum number of revs that can be reached with SET+ is identical for all modes (PTO mode 0 and PTO modes 1, 2 and 3). The idle speed rate setting range is identical for all modes.

The settings indicated in the table below must not be modified for PTO mode 0 (run mode). Table 4.4 (1) N LL N ° revs when idling. 4.6.3 Configurable PTO 1, 2, 3 modes IVECO Service can program three different, independent PTO mappings (engine operation settings) in the engine ECU (PTO). Obviously, the engine can only run according to one PTO mode at a time. The following priority order is used to solve this problem: − PTO mode 3: high priority − PTO mode 2: medium priority − PTO mode 1: low priority − PTO mode 0: driving mode These priorities must be taken into account during reprogramming. Problems may arise if the sequence is not respected and the PTO wiring may need to be modified.

Alternatively, the engine PTO ECU may need to be reconfigured, etc. ! PTO management Base - July 2006 Revi - June 2007 Print 603.93.431 Button Function Resume/OFF To switch the intermediate rpm ratio on/off. The intermediate rpm ratio is programmed by default at 900 rpm and can be changed by the driver. SET+/SET- To increase/decrease the intermediate rpm ratio. Accelerator pedal Active Maximum rpm which can be reached with SET+ button or accelerator pedal NLL(1) ÷ 2700rpm (2500 rpm for engines E28) Output torque Maximum specific vehicle torque Conditions for deactivating intermediate rpm ratio - Operate brake or clutch pedal - Activate CC OFF - Operate engine brake - Operate retarder