Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

POWER TAKE-OFFS 4-19 E URO C ARGO E URO 4 - 5 4.6.5 Standard configurations The default settings are shown in the table. Table 4.7 PTO mode Enabled using 21 pin connector No enablingis required Pin 17 and 16 connected Pin 18 and 16 connected Pin 19 and 16 connected Maximum N ° of revs that can be reached with SET+, N SET_max 2700 rpm (2500 rpm for E28 engines) 1800 rpm 1700 rpm 1900 rpm The engine revolutions can be increased or decreased by 250 rpm using the key SET+/SET-.

PTO management Print 603.93.431 Base - July 2006 Revi - June 2007 Mode 0 Mode 1 Mode 2 Mode 3 Max torque Maximum engine torque Maximum engine torque Maximum engine torque Maximum engine torque Minimum N° of revs that can be reached with SET-, NSET min _ 700 rpm 800 rpm 1050 rpm 700 rpm Maximum N° of revs, Nmax Runaway speed regulator gradient Dependent on nominal curve ~1CV/rpm ~1CV/rpm ~1CV/rpm Accelerator pedal Active Active Active Disabled Use of the CC buttons (Resume/OFF/SET+/SET-) Active Active Active Disabled N° revs stored, Nres 900 rpm 1100 rpm 1300 rpm 1450 rpm ”TIP” function for SET+/SET- Active Active Active Active Maximum speed of the vehicle, above which PTO mode is disabled, VZDR max _ 25 km/h 30 km/h 30 km/h 0 km/h Exclusion of PTO mode using brake or clutch Active Disabled Disabled Active Call-up intermediate speed regime stored on enabling PTO mode Active Disabled Disabled Disabled Exclusion of PTO mode (using parking brake) Disabled Disabled Disabled Active