Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

POWER TAKE-OFFS 4-20 E URO C ARGO E URO 4 - 5 4.6.6 Specific indications: correlation between the PTO configuration and the installed power take offs There is no direct connection between the PTO and power take off mode (which can be activated using the 21-pin connector) and the power take offs physically fitted to the vehicle. Therefore, the bodybuilder can define the necessary connections as suits him. This set up therefore makes it possible to use the power take off(s) with the various PTO configurations (for example, for particular work cycles).

Should a work cycle be established, for example, in which the fitted power take off is made to operate in different conditions, then up to a maximum of 3 modes for the PTO power take off can be used. The corresponding power take off modes must be activated from the body/ancillary at the relevant times. In a similar way, it is possible to correlate a power take off mode even without there being a power take off physically fitted to the vehicle, or conversely when there is more than one fitted. 4.6.7 Engaging the power take off The power take-offs fitted on the gearbox can only be engaged with the clutch fully pressed.

The power take-offs mode, on the other hand, can be enabled independent of the above. With Allison Gearbox When the vehicle has an Allison gearbox, the selection of the power take off is co-ordinated by the gearbox central control unit. The operation uses the following procedure: − request to engage the power take off (the gearbox central control unit checks the internal conditions so that the operation can be effected safely:

engine speed less than 900 rpm and output speed from the gearbox less than 250 rpm); − the solenoid valve used to engage the power take off is activated by the central control unit; − if the power take off and handbrake are engaged at the same time, the gearbox is automatically put into neutral, and PTO power take off mode 2 is activated; (a relay is supplied with power, located at: the relay plate on the gearbox central control unit, found on the rear wall of the cab); − a check is made that the power take off is functioning safely (output speed from the gearbox less than 300 rpm). The button for engaging the power take off is located in the central section of the dashboard.

Beforeengaging thepower takeoff, thegearbox centralcontrol unit checks anumber of parameters (engine speed is less than 900 rpm and output speed from the gearbox is less than 250 rpm). If all the necessary conditions inside the gearbox are satisfied, the Allison gearbox central control unit automatically engages the power take off. The restrictions (end speed, maximum torque etc) for the PTO power take off mode selected therefore remain valid even while the engagement takes place. Certain values may be modified by Allison Customer Assistance, as required by the bodybuilder. ! PTO management Base - July 2006 Revi - June 2007 Print 603.93.431