POWER TAKE-OFFS 4-21 E URO C ARGO E URO 4 - 5 Use of the power take-off with vehicle in motion If restrictions are not required (e.g. restrictions on torque, reduced maximum number of engine revs, etc) when the power take off is engaged, it is not necessary to use any PTO power take off mode. In this case, however, the engine power available for running the vehicle is reduced (given that power is being taken simultaneously by the ancillary). This could lead to acceleration problems. In typical usages (e.g. cement mixers, refuse collection vehicles etc) this problem can be minimised by increasing the idling speed.
This increased number of revs would, however, also then be present even when the power take off was disengaged. In general, a reduction in the maximum torque in this field of operation would not be considered sensible. If, however, restrictions are required (e.g. restrictions on torque, reduced maximum number of engine revs, etc) then an PTO power take off mode should be used. Particularly when the vehicle is operational, care must be taken to ensure that if an PTO power take off mode is activated, then the stored intermediate number of revs must also be activated at the same time. This could, however, result in an unexpected increase in vehicle speed.
It is the bodybuilder’s responsibility to ensure that the chosen solution is safe. ! The engagement or disengagement of the power take off depends both on the power take off chosen and the requirements of the bodybuilder. Regarding vehicle operation (up to a maximum speed of 25 km/h) with an increased number of revs when the power take off is engaged. For a range of applications, (e.g. use of a tipping body, cementmixer, refuse collection etc) higher revs are also required during operation. This can be achieved using the following set up: − Stored intermediate number of revs Nres: fixed programming − Intermediate number of revs (Nres):
as defined by the bodybuilder − Disengagement of the intermediate number of revs: deactivated via the clutch or brake pedals − Accelerator pedal: activated − CC Buttons: deactivated In this way, the engine can only operate again when the accelerator pedal is regulated between the stored intermediate number of revs, Nres, and the maximum number of revs, Nmax. If VZDR-aus is ever reached, the intermediate number of revs and therefore also the increase in revs is deactivated. Changing the stored intermediate number of revs N res The intermediate number of revs can be modified separately for each PTO power take off mode. It is necessary to distinguish between two possibilities:
1 Fixed programming (E.A.SY.) For mode 0 power takeoff (driving mode), this mode is not available. A modification is only possible by reprogramming the E.A.SY. test tool at IVECO Service 2. Free programming (by the driver) To modify the intermediate number of revs, the following procedure is used: a) select the particular PTO power take off mode whose intermediate number of revs are to be b) set the desired intermediate number of revs using the SET+/SET- button; c) press CC Resume for more than 5 seconds. Note: The use of the MODUS station must take place after an upgrade is run using E.A.SY. software PTO management Print 603.93.431 Base - July 2006 Revi - June 2007