POWER TAKE-OFFS 4-23 E URO C ARGO E URO 4 - 5 Influence of the exhaust brake on the intermediate number of revs The engine brake can be activated by: 1 Pressing the engine brake pedal (on the cab’s floor). 2 Pressing the brake pedal (when the brake is pressed the engine brake is automatically activated). 3 Pressing the accelerator pedal (at idling speed the engine brake is automatically activated). Selections can be made by means of a switch placed on the dashboard. If the engine brake is activatedin anymanner as described above (2 or3) the governor deactivates automatically. When the engine brake pedal is pressed, the CC push button functions (CC OFF/Resume/SET+/SET-) are disabled.
Simultaneous operation of SET+ and SET- These functions are mutually exclusive. Should both be activated simultaneously, then for safety reasons the CC Off button is activated immediately or after 500 ms. If, however, the buttons were pressed simultaneously, the engine’s EDC central control unit recognises an error after 500 ms (EDC error 1.3, control device). Second speed limiter This function can be activated independently of the various PTO power take off modes (driving mode 0, power take off modes 1, 2 and 3). IVECO Service can set the value using a E.A.SY. station. The second speed limiter is activated using a closed contact between pins 1 and 2 of the 5-pin connector. Note:
The use of the MODUS station must take place after an upgrade is run using E.A.SY. software PTO management Print 603.93.431 Base - July 2006 Revi - June 2007