Department of Defense MIL-HDBK-816 Notice 1 — MIL-HDBK-816 Notice 1 Radiation Hardness Assurance Guidelines Manual PDF

Downloaded from https://www.everyspec.com MIL-HDBK-816 NOTICE 1 Radiation hardness assurance - The application of methods and procedures during the procurement of an electronic system to ensure that the radiation response of the system is within known and acceptable limits. Radiation hardness maintenance - Procedures applied during the deployment phase to ensure that the system’s operational procedures, maintenance requirements and aging characteristics maintain the system’s hardness. These procedures include tests and inspections.

Radiation hardness surveillance - Periodic inspection and testing during the lifetime of deployed systems to ensure that, within acceptable tolerances, the radiation responses of the systems remain adequate for mission completion. RHA devices - Parts labeled by letter designators which indicate that the part type has passed lot acceptance tests based on a sample of devices tested to the device specification radiation levels. Selected item drawing - A specification that is written against any standard part when the system design has a critical requirement not covered by the standard part specification (QML or SMD). The acronym for this term is SID.

Standard microcircuit drawing - A specification written for parts which are listed in MIL-HDBK-103 and/or QML-38534 or QML-38535, and for which DSCC has a certificate of compliance to MIL-PRF-38534 or MIL-PRF-38535. Approved sources of supply are listed on this drawing. Periodic compliance verification audits are performed that data do not contain any faulty measurements or nonrandom effects. The data should be examined also for sufficiency.

Data examination is all the more important when a significant amount of time has elapsed between the characterization measurements and the data analysis or when the person or organization undertaking the data analysis is different from the persons who took the data in the first place. Some of the most common reasons for suspecting that data may be bad are discussed below. 4. GENERAL CONSIDERATIONS 4.1 Device performance in the radiation environment. Many military and civilian electronic systems must operate reliably in radiation environments.

The design of such systems therefore requires that the performance of the individual component semiconductor devices in radiation environments be characterized. The production of the systems then further requires that the parts purchased for production have characteristics at least as good as those on which the design was based. These guidelines discuss how to characterize the performance of semiconductor devices in radiation environments and how to obtain hardness assurance through device procurement specifications based on the characterization data.

Applications to an existing system of military standard or QML detailed specifications for Radiation Hardness Assured (RHA) devices are emphasized but the discussions may be applied also to other part specifications. Radiation hardness assurance is generally achieved through the use of Lot Acceptance Test (LAT) in which parts from the lot being purchased are irradiated and tested.

Because the military standard lot acceptance tests rely largely on pass-fail tests in which a part’s performance is compared to a specified end-point limit, these guidelines discuss, specifically, how Radiation Hardness Assurance End- Point Limits (RHEPL) for such tests should be calculated from the characterization data. 4.1.1 Degrading effects of radiation. The performance of semiconductor devices can be degraded by exposure to radiation which produces ionization or displacement damage.

Depending on the type of radiation incident on the device, the rate at which energy is absorbed, and the total accumulated amount of absorbed energy, the device performance can be degraded permanently or temporarily. Examples of temporary degradation are: (a) circuit upset due to the instantaneous photocurrent produced throughout the device by a short pulse of high intensity ionizing radiation or (b) circuit upset due to the collection of charge from a single, local, ionized particle track passing through the device. Upsets due to photocurrents are commonly called dose rate upsets; upsets due to the collection of charge from single ionized tracks are called Single Event Upsets (SEUs).

Examples of permanent damage are: (a) device failures due to atomic displacements produced in the semiconductor (usually by neutrons), (b) failures due to trapped charge in insulating layers, which are present in most SUPERSEDES PAGE 8 OF MIL-HDBK-816 8