131 Electromagnetic Compatibility 5.5 Legislation and Standards Legislation vs. standards Legislation is issued by the legislative branch of national or local government and is mandatory to comply with – it is law. It is a political document, free of specifi c technical details – these details can be found in standards. Standards are written by experts in relevant standardisation bodies (such as the International Electrotechnical Commission IEC or the European Committee for Electrotechnical Standardisation CENELEC) and refl ect the technical state of the art. Their role is to establish a technical common ground for cooperation between market players.
European EMC Directive The latest EMC Directive is 2014/30/EU and comes into force on the 20th of April 2016 replacing the previous directive 2004/108/EC. This directive is a legal requirement in the European Union. In essence the requirements are simple: • Products must not emit unwanted electromagnetic interference (limits emission) • Products must be immune to a reasonable amount of interference (sets immunity requirements) The directive itself is a political document and gives no specifi c technical requirements. A producer has the possibility of using harmonised standards to demonstrate compliance with the directive.
Compliance with the EMC Directive (and also with other relevant directive such as the Low Voltage Directive – LVD) is stated in the product’s Declaration of Conformity and the “CE” mark is affi xed to the product. The scope of the EMC Directive consists of following two categories: • Apparatus: a fi nished appliance made commercially available as a single-function unit and intended for the end user. Apparatus complying with the requirements of the Directive are marked with the CE mark • Fixed installations: a combination of apparatus or other devices which is permanently installed at a predefi ned location.
Fixed installations are built following “good engineering practices” and respecting the information on the intended use of its components. Fixed installations are not CE marked EMC Standards There are diff erent categories of standards, as follows: • Basic standards deal with general aspects such as test set-up, measurement technique and emission lines. For adjustable speed drives the emission limits specifi ed in EN55011 are commonly used