160 Interfaces This, however, comes at a price, as such systems are relatively expensive both to install and extend, as each additional parameter or drive requires new cabling, PLC programming and often more I/O hardware. For owners this means higher capital costs and restricted fl exibility. At the same time the risk of error is high, as the risk of a faulty connection to the PLC increases with the number of cables. Fig. 8.7 Traditional wiring. No fi eldbus Fieldbus wiring A typical fi eldbus system only uses twisted pair cables to connect the drive to the PLC. Despite the higher cost of components, fi eldbus systems off er several advantages over older, hardwired systems:
fewer cables, faster commissioning and a reduced risk of faults. Additional drives are connected in a serial Ethernet-based network that can be extended easily. New parameters only need to be coded into the PLC, which is both faster, safer and at signifi cantly lower cost than a hardwired system. Fig. 8.8 Fieldbus wiring