161 Interfaces Fieldbus over Ethernet The Ethernet interface enables the possibility to access drive parameters and information from locations outside the production facility. This method bypasses the traditional control hierarchy, as communication with the fi eldbus-fi tted drives and other equipment does not necessarily need to pass through the PLC. External access is routed through a fi rewall, enabling communication with the fi eldbus option’s built-in webserver. Not only does this provide a high degree of fl exibility during commissioning, it also provides advantages such as external monitoring and application support. Fig.
8.9 Fieldbus over Ethernet 8.5 Fieldbuses Standardisation The development of fi eldbuses began in the 1980s so that the benefi ts of serial communication could also be used in the fi eld. The driving force for the development included not only the potential to save cost and time during planning and installation but also the ease of expansion and increased interference immunity when transmitting analogue signals. In the years that followed, it became clear that the success of a system depends not only on industrial capability in a demanding environment but also on “openness”.
In open-bus systems, the installation and control are the same, irrespective of the manufacturer of the bus components. The end user can therefore replace a (defective) device from one manufacturer with a device from another manufacturer without having to make major changes to the system.