92 Frequency Converters and Motors Another function in some FC’s is called the Droop function. Droop function means that one motor is controlling the speed and additional FC’s follow the same speed and automatically share the load. Example A 100 meter long conveyor belt has numerous drive stations distributed along the belt. If one of the motors tends to run a bit faster than the other, this motor will have to give more torque. The result can be: • The motor can be overloaded and overheated • The belt can be damaged because of the partial higher torque • Pulleys and drive drums may slip with excessive wear as result In such situations, torque and torque sharing is important.
3.4.5 Watchdog FC’s can monitor the process being controlled and intervene in case of operational disturbance. This monitoring can be divided into three areas: machinery, motor, and FC. The machinery is monitored by • Output frequency • Output current • Motor torque Based on these values, a number of limits can be set which intervene in the control function if they are exceeded. These limits could be the lowest permissible motor speed (minimum frequency), the highest permissible motor current (current limit) or the highest permissible motor torque (torque limit). If the limits are exceeded, the FC can, for example, be programmed to:
• give a warning signal, • decrease the motor speed or • stop the motor as fast as possible Example In an installation using a V-belt as a connection between the motor and the rest of the installation, the FC can be programmed to monitor the V-belt. As expected, the output frequency increases more quickly than the preset ramp. If the V-belt breaks, the frequency can be used to either give a warning or stop the motor.