95 Frequency Converters and Motors 3.5.3 Brake Chopper Circuit (Brake Module) and Resistor The circuit essentially consists of a transistor (for example, IGBT ) that eliminates the excess voltage by “chopping” it and sending it to the connected resistor. The control circuit must be fed with the appropriate information during commissioning that a braking resistor is connected. The control circuit can also check whether the resistor is still in working order. Typically it must be specifi ed if an FC is equipped with a brake chopper or not, at the point of ordering. Above a certain power level, the use of a braking module and resistor will cause heat, space and weight problems.
Braking resistor Control logic Fig. 3.11 Brake “chopper” and resistor 3.5.4 Use of a Regenerative Braking Unit If the load often generates a great deal of regenerative energy, it may be useful to use a fully-regenerative braking unit. If the voltage in the intermediate circuit rises to a given level, the DC voltage in the circuit is fed back to the mains, synchronously in both amplitude and phase, by an inverter. This feedback of energy can be accomplished by: • FC’s with an active rectifi er.
In this FC type, the rectifi er can transmit energy from the intermediate DC circuit to the power supply • External regenerative braking units integrally connected to the intermediate circuit of one or more FC’s, monitor the voltage in the intermediate circuit.