Mitsubishi — 3.12.1 Functions of Special Registers for Manual Mode Settings

3 Functions of Devices in DVP-PM Forward running occurs when P(I) is bigger than CP. Reverse running occurs when P(I) is smaller than CP. ♦ The operation speed will be stable after the speed is accelerated from V BIAS to the expected V(I). When it is approaching the P(I) value set in the register, the positioning will start to decelerate to V BIAS and stop. There are P(I) pulses generated during the positioning. ♦ The registers involved: D1824 (D1904, D1984, D2054) (V BIAS ), D1840 (D1920, D2000, D2080) (V(I)), D1822 (D1902, D1982, D2062) (V MAX ), D1838 (D1918, D1998, D2078) (P(I)), D1836 (D1916, D1996, D2076) (T ACC ) and D1837 (D1917, D1997, D2077) (T DEC ).

Speed Start Time ♦ When PWM mode is enabled (Parameter Setting, D1816/D1896/D1976/D2056, b[6] = 1), and the operation command “Single-speed positioning” is enabled (b[8] = 1), single-speed positioning will be executed on Y0~Y3 with single-phase pulses. 10. b9 of D1846 (D1926, D2006, D2086): enabling single-speed positioning interruption ♦ When b[9] is triggered and START = ON, the single-speed positioning interruption mode will be started. The single speed insterruption will be triggered to execute target position P(I) when DOG sensor is detected. ♦ Operation direction: Direction of relative positioning is determined by the sign bit of the value for P(I) (set in D1838, D1918, D1998).

Direction of absolute positioning is determined by current position (CP). Forward running occurs when P(I) is bigger than CP. Reverse running occurs when P(I) is smaller than CP. ♦ The operation speed will be stable after the speed is accelerated from V BIAS to the expected V(I). When DOG sensor is detected, the single speed insterruption will be triggered to send out pulses set in P(I) to V BIAS and stop. register. Also, when it is approaching the P(I) value set in the register, the positioning will start to decelerate ♦ The registers involved:

D1824 (D1904, D1984, D2054) (V BIAS ), D1840 (D1920, D2000, D2080) (V(I)), D1822 (D1902, D1982, D2062) (V MAX ), D1838 (D1918, D1998, D2078) (P(I)), D1836 (D1916, D1996) (T ACC ) and D1837 (D1917, D1997, D2077) (T DEC ). DVP-PM Application Manual 3-71 T ACC V MAX V BIAS