3 Functions of Devices in DVP-PM Note: 10M = DVP10PM, 20D = DVP20PM00D, 20M = DVP20PM00M DVP-PM Application Manual 3-22 OFF MANU AUTO Special Page Function 10M 20D 20M Ø Ø Ø Attrib.
Latched Default M number ON AUTO MANU M1831* Enable current position write in function on Y-axis ○ ○ ○ OFF - - R/W NO OFF 3-44 M1841* Stop Y axis movement at fixed position ╳ ○ ○ OFF - - R/W NO OFF 3-44 M1872* Y axis ready flag ○ ○ ○ ON ON ON R NO ON 3-44 M1873* Error flag of motion subroutine on Y axis; (automatically cleared when Y axis is re-activated) ○ ○ ○ OFF - - R NO OFF 3-45 M1908 Input signal control of C200/C204 ╳ ○ ○ OFF - - R/W NO OFF - M1909 Virtual Master setting 1 ╳ ○ ○ OFF - - R/W NO OFF M1910 Virtual Master setting 2 ╳ ○ ○ OFF - - R/W NO OFF M1920 Radian / degree selection in O100 ○ ○ ○ OFF - - R/W NO OFF - M1952 O100 ready flag ○ ○ ○ ON OFF ON R NO ON - M1953* Error flag of O100 ○ ○ ○ OFF OFF - R/W NO OFF 3-50 M1957 Indicate AUTO / MANU (STOP / RUN) status ○ ○ ○ OFF ON - R NO OFF - M1968 Zero flag for O100 ○ ○ ○ OFF - - R NO OFF - M1969 Borrow flag for O100 ○ ○ ○ OFF - - R NO OFF - M1970 Carry flag for O100 ○ ○ ○ OFF - - R NO OFF - M1971 Error flag for O100 floating point operation ○ ○ ○ OFF - - R NO OFF - M1985 Disable zero return of Z axis ╳ ╳ ○ OFF - - R/W NO OFF - M1991* Enable current position write-in function on Z-axis ○ ○ ○ OFF - - R/W NO OFF 3-44 M2001* Stop Z axis movement at fixed position ○ ○ ○ OFF - - R/W NO OFF 3-44 M2032* Z axis ready flag ╳ ╳ ○ OFF ON ON R NO ON 3-44 M2033* Error flag of motion subroutine on Z axis; (automatically cleared when Y axis is re-activated) ╳ ╳ ○ OFF - - R/W NO OFF 3-45 M2065 Disable zero return of A axis ○ ╳ ╳ OFF - - R/W NO OFF - M2071* Enable current position write-in function on A-axis ○ ╳ ╳ OFF - - R/W NO OFF 3-44 M2112* A axis ready flag ○ ╳ ╳ ON ON ON R NO ON 3-44 M2113* Error flag of motion subroutine on Z axis; (automatically cleared when Y axis is re-activated) ○ ╳ ╳ OFF - - R/W NO OFF 3-45